top of page

The Chandler Limited Germanium Pre Amp/DI is a completely new microphone pre-amplifier design by Chandler Limited designer Wade Goeke that uses classic germanium transistors in an all class A, transformer balanced circuit.

 

The use of germanium devices opens a whole new sound palate not found in any pro audio equipment currently manufactured.

 

These incredibly smooth sounding transistors were the basis of the earliest transistor designs by Neve (1053, 1055, 1057), EMI (TG12345 MKI), Telefunken, and Fairchild. Those familiar with these units can attest to the special sound of the germanium transistor. The GERMANIUM series runs on +40 volt power, high current, and has a huge +34 output before clipping. The sound is warm and smooth, as with many vintage style circuits, but you'll find a whole new world of smooth here, as well as a sound that settles in perfectly to your tracks without fighting. The Germanium uses Chandler's new custom wound transformers that combine the best parts of our favorite St Ives and Gardners input and output transformers.


All Germanium units require and function on the PSU-1, Chandler Limited power supply. The PSU-1 has an internal switch for setting voltage to 120V or 220V (115V/230V).

 

Chandler Limited is the only company in the world authorized to develop, manufacture and market the “Official Equipment” of EMI/Abbey Road Studios.

Chandler Limited and their associated logos are registered trademarks of Chandler Limited, Inc. Abbey Road Studios, EMI, TG, REDD and RS and their associated logos are trademarks of EMI (IP) Limited.

Chandler Limited Germanium Mic Preamp

$1,195.00Price
Quantity
This unit ships directly from the manufacturer. Please email sales@redbeardproaudio.com for current lead times.
  • DI Input

    Unbalanced 1/4" jack with 100k input impedance

    Germanium Drive Control

    Controls the input gain of the Germanium amp. The amount of gain from this is related to the Feedback control position.

    Pad and "Thick" switches

    - Both of these can be used to greatly control the tone of the pre amp. Use Pad to run the Drive and Feedback controls near full for increased low end and harmonic distortion. The thick adds a gentle low frequency rise for warmth and roundness.

    Feedback Control

    Controls the amount of signal fed from the amplifier output back into its input, as well as acting as a volume type control. This knob seriously affects the tone of the unit. With feedback to the left there is less volume, less Total Harmonic Distortion, lower noise floor, and more high frequencies. With feedback to the right there is more volume, more Total Harmonic Distortion, and a low end peak around 30hz. Combine this with the Germanium Drive control, Thick, and Pad switches for a cool variety of sounds.

    VU Range switch

    - Low range -12 to +3 db. High range +5 to +20 db.

    VU Meter

    10 segment LED meter that shows the unit output in two ranges.

    48 volt and Phase Reverse switches

  • Channels

    - Mono

    Circuit

    - Discrete, Transistor

    Gain

    -5 to +65 db

    Mic Input Impedance

    - 1200 to 300 Ohm

    I/O

    - XLR, Transformer Balanced, Pin 2 Hot

    DI

    - 1/4″ Unbalanced, 100k input impedance

    Phantom Power

    +48v

    Power

    +/-28v

bottom of page